|
Sulfanol SIL
Sulfanol
SIL is a high performance low
viscosity silicone based foam
suppressant for all types of
high turbulent operations at
elevated temperature.
Your
advantage
§
Cost effective
§ Low dosage application
§ Suitable for all machines
§ Compatible with all chemicals
Features
§
Sulfanol SIL can effectively
control foaming in garment dyeing
due to heavy
agitation
§ Sulfanol SIL is stable
at high temperature over a wide
range of pH.
§ Sulfanol SIL controls
excessive foam at a very low
dosage level where foam can
causes entanglement of the fabric
leading to damage of the fabric.
§ Sulfanol SIL is stable
to electrolytes
| Typical
Properties |
| Type |
Nonionic. |
| Appearance |
Milky white
free flowing emulsion. |
| Composition |
Blend of
siloxanes. |
| Solubility |
Readily
dispersible in water at
room temperature. |
Storage
Store in a cool dry
place. Stable under normal conditions.
Health
and Safety
Health and handling
advice on these products is
given in individual data sheets,
available upon request.
Application
1.Preparation
of Solution
Sulfanol SIL
is diluted with water below
600C with good agitation and
prepared on a daily basis and
the diluted material should
be used within 24
hrs for best results.
2.Garment
processing
0.05-0.2g/l Sulfanol
SIL can effectively
control unwanted foaming in
garment dyeing.
3.Fabric
processing
0.05g/l Sulfanol SIL
or lower dosages have been found
effective in
scouring and bleaching baths.
4.Polyester dyeing
0.05-0.2g/l Sulfanol
SIL is used in disperse
dye bath to ensure adequate
foam control
Technical
enquiries should be addressed
to:
Sulfast
Chemical Industries
1st Floor, 254-B, Nirlon House,
Dr.A.B.Road, Worli, MUMBAI-400
030
Tel : 91 22 4049 7700 Fax: 91
22 4049 7701 e-mail - sales@sulfast.com
website – www.sulfast.com
SulfanolTM,
SulfaxilTM and SulfanineTM are
registered trademarks of Sulfast
Chemical Industries.
The information
and recommendation in this publication
are to the best of our knowledge,
information and belief accurate
at the date of publication.
Nothing herein is to be constituted
as a warranty, express or otherwise.
In all cases, it is the responsibility
of the user to determine the
applicability of such information
or suitability of any product
for their own particular use.
All sales of these products
shall be subjected to Sulfast
Chemical Industries standard
condition of sale Revision 1
08/07
|
